Before covering the gear legs, the brake lines were installed inside. I'm using 1/4" aluminum tubing. The connection at the top is a 90 degree elbow bulkhead fitting (AN833). Adel clamps secure the tube to some tabs that were welded on during construction.
Here the covering process for the gear leg begins:
Here it is after covering and shrinking, but before Poly Brush:
I like the step transition.
An inspection ring was installed on the backside, just in case I ever need
to access the bulkhead fitting:
When covering the Rudder, don't forget to run your tail light wires first
(if you have a tail light):
Here is the rudder covered:
The tail light opening on the rudder:
On the rudder hinges, I just left them covered for now and will final trim
them after shrinking.
Click here to go to Fabric Covering page 9